Action Can RX-90 Red Oxide Anti-Rust Primer

RX-90 Red Oxide Anti-Rust Primer is a fast drying protective coating for use on all metal
surfaces. The modified alkyd resin binder and anti-corrosion pigments present protect
against rust and provide an additional anti-corrosion layer for subsequent topcoats.
RX-90 exhibits strong adhesion on degreased, bare metal surfaces and is paintable with all
one-component paints after 1 hour. RX-90 can be welded through.

Appearance

Dark red coating

Odour

Solvent

Resin Type

Epoxy modified alkyd

Touch Dry

30 minutes

Full Cured

16 hours

Maximum Temperature Resistance of Cured Film

110°C

Minimum Application Temperature

5°C

Coverage

1.5 to 2.0 m2 per can

Dry Film Thickness

Approximately 30 µm

• Technical Data Sheet
• Safety Data Sheet

• Use in a well ventilated area.
• Remove any rust and scale with a wire brush.
• Ensure that the surface to be coated is clean, dry, and free from grease.
• RX-90 now has a safety ring under the button that must be levered out using a flat-headed screwdriver.
• RX-90 contains solids which settle during storage. Shake the can vigorously until the agitator ball is free and continue shaking for a further minute.
• Shake the can periodically during application.
• Apply in light, even coats from approximately 20 cm - best results are obtained by 2 light coats rather than one heavy coat.
• Additional coats can be applied after 15 - 20 minutes.
• When spraying is finished, clean the aerosol valve by turning the can upside down and spray until only propellant escapes.
• Do not use on energised equipment.